A bicycle chain is known for not having the worst time. This problem of a chain of Jumpy or steps can be removed completely, but if you do just a little 'maintenance chain regularly. This means that you check the chain at least twice a month or once you go up to about 10 hours if you drive a bit '. Want to be sure to find something out of the string if you were riding in bad weather.
You should replace the chain if it is rusty, strained, worn, or has traveled more1000 miles on it. A new chain with 24 links should measure 12 inches and is too long even 1 / 16 of an inch, then you want to replace it so as not to prejudice the bridge or crown. If you replace the links in the chain and sprocket, then you should go ahead and replace the string so as not to damage the links in the new chain and sprocket.
The metal parts of the chain is not really an exaggeration, but the chain does not anymore because the sleeves and pins of wear.Lubricating the chain regularly will help the chain last longer. If you want to lubricate properly, then you put a drop of lubricant in each chain pin. This may take some time, but will be very useful when you increase the length of your chain.
Leave the oil on the chain for about 15 minutes, then remove the excess with a clean cloth. This will help keep the chain to capture dirt and grime while driving. It will also take the chainperfect condition.
If you need to clean the chain motion, then you can use a degreaser or dish soap. This is a great way to remove grease, dirt and grease to help your supply chain work better. After cleaning, do not forget to lubricate it again. You can place the cleaner in the center of the cloth or sponge, then place around the chain. From backpedaling, you need to clean the chain sufficient. Be sure to wash the cloth in each round until you get no more dirton it.
Leave the chain on the bike when you are cleaning to avoid becoming weaker. Then you have found the clean channel, so you can review all the links that may be too narrow. A tight chain can cause the chain to jump and shoot. If you find a link that is tight, then you can detach from the drop between two points that are about giving the links on the close link. If you are unable to take off, then you should replace the chain. Keep the bicycle chainoiled and cleaned the help last much longer and work better.
If your channel seems to make some 'noise and cleaning does not stop the noise, so you must replace it. If it becomes difficult to pedal, it's time to change channels as well. By paying attention to details and maintenance, then you have a bicycle chain that can be used for a long time.
0 ความคิดเห็น:
แสดงความคิดเห็น